factory h-pipe for 5.0 foxbody
3 posters
Page 1 of 1
factory h-pipe for 5.0 foxbody
56Tbird March 9th 2012, 11:23 pm
Does anybody have one laying around that you wouldn't mind cutting the flanges off the back of it? I had my exhaust worked on ,and the guy cut the flanges out and welded the pipe straight in. I'm looking at ordering a complete system that comes ready to bolt on to the factory h-pipe. I need them back on it ,so I can unbolt it to pull the tranny if needed.
56Tbird- BBF CONTRIBUTOR
- Posts : 5260
Join date : 2008-12-02
Age : 65
Location : Hawesville,Ky.
Re: factory h-pipe for 5.0 foxbody
Barney March 10th 2012, 12:35 am
Flow master makes ball flanges to put back on if you can't find a stock h pipe.
Barney- Posts : 2577
Join date : 2009-12-02
Age : 48
Location : Kirkland, Il -
Re: factory h-pipe for 5.0 foxbody
56Tbird March 10th 2012, 10:07 am
Thanks Barney, I may have to go that route?
56Tbird- BBF CONTRIBUTOR
- Posts : 5260
Join date : 2008-12-02
Age : 65
Location : Hawesville,Ky.
Re: factory h-pipe for 5.0 foxbody
bbf-falcon March 10th 2012, 10:43 pm
Dan,if you can hold off until the columbus swap,I know a guy that will bring you some there.
bbf-falcon- Posts : 8995
Join date : 2008-12-03
Location : Jackson, Ohio
Similar topics» Pipe stands
» X-pipe diameter
» X-Pipe orientation
» Tube/Pipe Bending?
» Air cleaner plumbing, is 6" pipe enough for a 545?
» X-pipe diameter
» X-Pipe orientation
» Tube/Pipe Bending?
» Air cleaner plumbing, is 6" pipe enough for a 545?
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum|
|
|