BIG BLOCK FORD
Would you like to react to this message? Create an account in a few clicks or log in to continue.

piston question

2 posters

Go down

piston question Empty piston question

Post  mustangjeff December 1st 2009, 9:19 pm

Do they make a tool to cut valve reliefs in pistons or do I need to take them back to machine shop? I had the pistons cut so they would be at zero deck & know I have zero clearance on exhaust valve. The intake relief is much deeper & is fine.

mustangjeff

Posts : 87
Join date : 2009-08-19

Back to top Go down

piston question Empty Re: piston question

Post  the Coug December 1st 2009, 9:21 pm

Isky makes one I think John Kaase also has one on his sight....


Randy
the Coug
the Coug

Posts : 3055
Join date : 2008-12-02

Back to top Go down

piston question Empty Re: piston question

Post  mustangjeff December 1st 2009, 9:24 pm

Do you think I could do it with pistons in engine if I used a shop vac while I was cutting?

mustangjeff

Posts : 87
Join date : 2009-08-19

Back to top Go down

piston question Empty Re: piston question

Post  the Coug December 1st 2009, 9:26 pm

yes bring the piston TDC and put grease around the piston and put cutter in the head and cut just make sure you cut slowly and make sure you know how deep you are going.... try to make each the same.... after lower the piston slowly and wipe the grease. should be ok....



Randy
the Coug
the Coug

Posts : 3055
Join date : 2008-12-02

Back to top Go down

piston question Empty Re: piston question

Post  mustangjeff December 1st 2009, 10:01 pm

Thanks for the help.

mustangjeff

Posts : 87
Join date : 2009-08-19

Back to top Go down

piston question Empty Re: piston question

Post  Sponsored content


Sponsored content


Back to top Go down

Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum