eddelbrock push rod guide plate part # or equivalent
2 posters
Page 1 of 1
eddelbrock push rod guide plate part # or equivalent
i need to replace a guide plate and have 3/8 push rods , on eddelbrocks site its says on back order or not available
I wasn't sure if there was another part # that i could use
Thanks
Andy
I wasn't sure if there was another part # that i could use
Thanks
Andy
5pointslow- Posts : 1400
Join date : 2009-10-11
Age : 35
Location : MASSHOLE aka BOSTONIAN
Re: eddelbrock push rod guide plate part # or equivalent
5pointslow wrote:i need to replace a guide plate and have 3/8 push rods , on eddelbrocks site its says on back order or not available
I wasn't sure if there was another part # that i could use
Thanks
Andy
Trick Flow, Comp Cams or even Speedmaster sell 3/8" guide-plates for production valve locations.
Re: eddelbrock push rod guide plate part # or equivalent
thanks i assumed it was good but never want to assume
thanks Randy
thanks Randy
5pointslow- Posts : 1400
Join date : 2009-10-11
Age : 35
Location : MASSHOLE aka BOSTONIAN
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|