Edelbrock Performer RPM - welded
4 posters
Page 1 of 1
Edelbrock Performer RPM - welded
JBR-3 January 2nd 2017, 11:41 pm
.
Last edited by JBR-3 on September 20th 2020, 12:23 pm; edited 1 time in total (Reason for editing : .)
JBR-3- Posts : 266
Join date : 2009-08-17
Re: Edelbrock Performer RPM - welded
dfree383 January 3rd 2017, 9:44 am
It won't lower the peak, it only allow the intake to think the carb is bigger
dfree383- BBF CONTRIBUTOR
- Posts : 14792
Join date : 2009-07-09
Location : Home Wif Da Wife.....
Re: Edelbrock Performer RPM - welded
rmcomprandy January 3rd 2017, 10:55 am
Welding the notch closed will lower the RPM point of peak torque and usually increase that number; unless the carb is to small.
You will lose peak RPM and "hang-on" power; about 1/2" of what you will gain in the very low RPM range under the peak torque.
You will lose peak RPM and "hang-on" power; about 1/2" of what you will gain in the very low RPM range under the peak torque.
rmcomprandy- Posts : 6108
Join date : 2008-12-02
Location : Roseville, Michigan -
Re: Edelbrock Performer RPM - welded
Scott Foxwell January 3rd 2017, 11:36 am
It's also going to want more carb.
Scott Foxwell- Posts : 419
Join date : 2011-06-23
Age : 65
Location : E Tennessee
Similar topics» edelbrock performer intake for a 460
» Edelbrock Performer 460 intake
» Edelbrock Performer vs. cast intake
» Edelbrock Performer RPM Heads
» Edelbrock Performer 460 For Sale
» Edelbrock Performer 460 intake
» Edelbrock Performer vs. cast intake
» Edelbrock Performer RPM Heads
» Edelbrock Performer 460 For Sale
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum|
|
|