timing chain for aligned bore blocks?
4 posters
Page 1 of 1
timing chain for aligned bore blocks?
powerstrokeace February 10th 2015, 10:59 pm
I have a block that was aligned bored and the chain that came off was pretty loose not very many runs. So i thought i would replace it with a -.005 smaller one. questing is? where do the make the -.005 adjustemnt? in the gears? and if so which one or both
Ace
Ace
powerstrokeace- Posts : 1496
Join date : 2009-09-07
Location : colorado
Re: timing chain for aligned bore blocks?
10.0 February 11th 2015, 6:07 am
Yeah, the gears are machined slightly larger.
I think i have an extra set up in the shop if you need one.
I think i have an extra set up in the shop if you need one.
10.0- Posts : 54
Join date : 2011-04-23
Re: timing chain for aligned bore blocks?
Doug Rahn February 11th 2015, 8:39 am
Cloyes has the chain and sprocket sets in just about all of their series that are available in .005 and .010 shorter sets.
Doug Rahn- BBF CONTRIBUTOR
- Posts : 1680
Join date : 2009-08-07
Age : 72
Location : Springfield, GA -
Re: timing chain for aligned bore blocks?
rmk57 February 11th 2015, 10:37 am
I thought the gear teeth weren't machined as deep, making the chain sit higher.
rmk57- Posts : 172
Join date : 2010-05-29
Similar topics» Advance Cam or Not ?
» Timing chain stretch
» Timing chain and oil pan questions
» Timing chain help
» Timing chain
» Timing chain stretch
» Timing chain and oil pan questions
» Timing chain help
» Timing chain
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum|
|
|