mini tubbing

Im mini tubbing my 89 hatch and for sure its my first time. Ive done some cutting but not dead on yet. I got some team z mini tubs and team z offset da lowers in the mail. When I get the tubs im going to final trim for them to fit. I been looking at the team z instructions but ild like to see some more pics of the lower torque box area if anybody got some or can point some out to me.
Thanks

I used Wolfes mini tubs and they fit great, it just took some time to make the cut rights...measure twice and cut once. as far as the torque boxes go I welded all the seams used these kits from UPR http://www.uprproducts.com/mustang-heavy-duty-lower-torque-box-kit.html on the bottom and these on top http://www.uprproducts.com/mustang-heavy-duty-upper-torque-box-kit.html
and then welded them to the car after the suspension was installed and tightened down. What are you using for sub frame connectors? I went through the floor from the toe kick and into the rear reals a foot. if I can figure out how to load photos I'll start a build tread. Check out the Wolfe site, he has some good photo's http://www.wolferacecraft.com/install/must/musminitub.aspx

I used the team z and followed their instructions had no problems at all

Go on YouTube and search TeamZ mini tub. They have a great 11-12 minute video on it...