.903 and .937 same cost - why not?
3 posters
Page 1 of 1
.903 and .937 same cost - why not?
windsor February 10th 2014, 10:32 am
.903 and .937 lifters are the same cost far as I can tell from a few different vendors...any reason NOT to do the .937 if I'm going bigger anyhow? Eliminator Premier block.
windsor- Posts : 1167
Join date : 2009-08-09
Location : St. Pete/Northern Va.
Re: .903 and .937 same cost - why not?
Lem Evans February 10th 2014, 12:14 pm
Are you talking tie-bar lifters? Make sure the cam people know the roller dia. before the cam is ground.
Lem Evans- Posts : 7445
Join date : 2008-12-03
Location : Livermore , Ky -
Re: .903 and .937 same cost - why not?
windsor February 10th 2014, 12:22 pm
Correct, Lem, not key way.
windsor- Posts : 1167
Join date : 2009-08-09
Location : St. Pete/Northern Va.
Re: .903 and .937 same cost - why not?
windsor February 10th 2014, 4:41 pm
So is it a go assuming I'm going bigger anyway?
(Assuming I don't go with the new morel hyd rollers)
(Assuming I don't go with the new morel hyd rollers)
windsor- Posts : 1167
Join date : 2009-08-09
Location : St. Pete/Northern Va.
Re: .903 and .937 same cost - why not?
CDMBill February 14th 2014, 1:47 am
Check with your Machine shop to be sure they have the .937 BBF lifter bore tooling.
CDMBill- Posts : 182
Join date : 2010-08-09
Re: .903 and .937 same cost - why not?
windsor February 14th 2014, 11:38 am
Will do indeed. Will likely use C&C close to me in Manassas. Pretty sure they have it 
windsor- Posts : 1167
Join date : 2009-08-09
Location : St. Pete/Northern Va.
Similar topics» My 533 SCJ by Charlie Evans Racing
» Cost Differential 468 vs 505?
» Cost to have Head work done?
» Bushwacker Fender Flares, New in Box.
» Head Flow Cost
» Cost Differential 468 vs 505?
» Cost to have Head work done?
» Bushwacker Fender Flares, New in Box.
» Head Flow Cost
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum|
|
|