Pinion Offset
3 posters
Page 1 of 1
Pinion Offset
Doug Rahn September 2nd 2011, 8:39 am
Someone correct me if my memory 
is wrong, but is the Ford blueprint pinion offset for the 9" @ .970" ?
is wrong, but is the Ford blueprint pinion offset for the 9" @ .970" ?
Doug Rahn- BBF CONTRIBUTOR
- Posts : 1680
Join date : 2009-08-07
Age : 72
Location : Springfield, GA -
Re: Pinion Offset
bosshoss September 2nd 2011, 1:47 pm
Dont know about the blueprint but I use 1 inch for my calculations.
dkp
dkp
bosshoss- BBF CONTRIBUTOR
- Posts : 499
Join date : 2009-08-10
Re: Pinion Offset
David Willingham September 2nd 2011, 2:08 pm
I would like to know what the "Ford" number is, but all my reverse engineering I did when I built this billet rearend housing showed .960" and that's what I used. I will add that the hole pattern for the 9" is all over the place. There is nothing symetrical or even about it. It makes no sense. I had to measure several different center sections and then just "SWAG" it, lol.
David Willingham- BBF CONTRIBUTOR
- Posts : 495
Join date : 2008-12-02
Age : 51
Location : Blountsville, AL
Re: Pinion Offset
Doug Rahn September 2nd 2011, 3:44 pm
Thanks! I think I remember reading it a while back on Yellow Bullet that someone had the Ford blueprints and .970 is sticking in my aging brain.
Doug Rahn- BBF CONTRIBUTOR
- Posts : 1680
Join date : 2009-08-07
Age : 72
Location : Springfield, GA -
Similar topicsPage 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum|
|
|